Advanced Design VMware NSX-T Data Center 3V0-42.20 training questions have been updated, which contain 57 Q&As. We know that 3V0-42.20 exam is a related test for VMware VCAP-NV Design 2021 certification. If you are preparing for this certification, you can choose to study the updated Advanced Design VMware NSX-T Data Center 3V0-42.20 training questions to pass the VMware 3V0-42.20 exam. 

 

 

The updated VMware VCAP-NV Design 2021 3V0-42.20 exam updated training questions can help you study the following topics: Architecture and Technologies, Products and Solutions, Planning and Designing, Installing, Configuring, and Setup, Performance-tuning, Optimization, and Upgrades, Troubleshooting and Repairing and Administrative and Operational Tasks. Share some updated VMware certification 3V0-42.20 training questions below.

 

1.Which two resources can be used by an NSX architect during the Assessment Phase? (Choose two.)

A. vRealize Network Insight

B. VMware Validated Design

C. VMware customer references

D. key stakeholder interviews

E. application licensing

Answer: AD

 

2.A customer wants to place their NSX Managers in different subnets. Which would an architect recommend to support the request? (Choose the best answer.)

A. Use a load balancer.

B. Use round-robin DNS.

C. Use NAT.

D. Use a cluster Virtual IP.

Answer: A

 

3.An architect is helping an organization with the Physical Design of an NSX-T Data Center solution. 

This information was gathered during a workshop:

- Current hypervisor of choice is KVM.

- Cost reduction is important.

Which two selections should the architect recommend to the organization? (Choose two.)

A. Deploy Edge VM Nodes using ISO.

B. Deploy NSX Manager using OVF.

C. Deploy NSX Manager using QCOW2.

D. Deploy bare metal Edge Nodes.

E. Deploy Edge VM Nodes on KVM.

Answer: CD

 

4.An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.

This information was gathered during a workshop:

The company will use a Leaf and Spine physical network architecture with Layer 3 gateways for top of rack switches.

The company is planning to deploy 120 ESX hosts across 10 racks.

There will be a total of a 12 clusters where each cluster has one host per rack.

What should the architect recommend to allow applications to run on any host in the cluster? (Choose the best answer.)

A. Deploy all application networks on NSX segments.

B. Deploy an L2 VPN to allow the networks to extend to each host.

C. Deploy a Tier-0 gateway per Rack and configure BGP between racks.

D. Deploy a Tier-1 gateway per Rack and configure BGP between racks.

Answer: A

 

5.An architect is designing a solution for containerization. The solution will include high availability and security using NSX-T Data Center. The architect plans to provide a basic required components list in the Logical Design. Which solution should the architect recommend? (Choose the best answer.)

A. 3 NSX Managers, 3 virtual NSX Edges, two Tier-0 gateways in Active/Standby, BGP configuration

B. 2 NSX Managers, 2 virtual NSX Edges, one Tier-0 gateway, BGP configuration and a static route

C. 3 NSX Managers, 3 virtual NSX Edges, one Tier-0 gateway and a static route and OSPF

D. 1 NSX Manager, 2 virtual NSX Edges, two Tier-0 gateways in Active/Active, BGP configuration

Answer: A