Latest CCNP Collaboration 300-815 CLACCM Training Questions
Cisco 300-815 CLACCM exam is a concentration test for Cisco CCNP Collaboration certification. Latest Cisco CCNP Collaboration 300-815 CLACCM training questions have been released, which are valuable for you to prepare 300-815 CLACCM tet. To clear 300-815 CLACCM exam easily, the following 300-815 CLACCM exam related information and training questions are helpful in the preparation.
300-815 CLACCM Exam Information
Implementing Cisco Advanced Call Control and Mobility Services 300-815 CLACCM exam tests your knowledge of advanced call control and mobility services, including signaling and media protocols, CME/SRST gateway technologies, Cisco Unified Board Element, call control and dial planning, Cisco Unified CM Call Control, and mobility. To complete Cisco 300-815 CLACCM exam, you have 90 minutes to finish.
Cisco 300-815 CLACCM Exam Topics
The following topics are general guidelines for the content likely to be included on the Implementing Cisco Advanced Call Control and Mobility Services 300-815 CLACCM exam.
Study Cisco 300-815 CLACCM Training Questions
There are 60 Q&As covered in Cisco CCNP Collaboration 300-815 CLACCM training questions. Share some Cisco certification 300-815 CLACCM training questions and answers below.
1.A company has an SRST gateway running an IOS XE image. The company plans to enable the IPv6 addressing companywide.To enable the IPv6 in a unified SRST gateway to support SIP phones, what are two supported supplementary features for an IPv6 fallback scenario? (Choose two.)
A. three-way conference
B. secure SIP lines
C. T.38 fax relay
D. transcoding
E. SIP trunk
Answer: AC
2.Which action is correct with respect to toll fraud prevention configuration in the Cisco Unified Communications Manager Express?
A. Configure Direct Inward Dial for Incoming ISDN Calls with overlap dialing.
B. Configure IP Address Trusted Authentication for Incoming VoIP Calls.
C. Configure the command no ip address trusted authenticate under “voice service voip”.
D. Enable Secondary Dial tone on Analog and Digital FXO Ports.
Answer: B
3.You see the voice register pool 1 command in your Cisco Unified Communications Manager Express configuration.Which configuration is occurring in this section?
A. configuration for a single SIP phone
B. configuration items common for all SIP phones
C. configuration for a pool of SIP phones (similar to device pool on Cisco Unified Communications Manager)
D. configuration for SIP registrar service
Answer: C
4.Refer to the exhibit.
A user reports that when they call a specific phone number, no one answers the call, but when they call from a mobile phone, the call is answered. The engineer troubleshooting the issue is expecting the far-end gateway to cut through audio on the 183 Session Progress SIP message.Which SIP Profile configuration element is necessary for the Cisco Unified Communications Manager to send acknowledgement of provisional responses?
A. Allow Passthrough of Configured Line Device Caller Information must be enabled.
B. Accept Audio Codec Preferences in Received Offer must be set to On.
C. On the SIP Profile, the configuration parameter SIP Rel1XX Options must be set to Send PRACK for all 1xx Messages.
D. Early Offer for G Clear Calls must be enabled.
Answer: C
